Can someone point me in the right direction?I have had a stanley erin stove replace my old back boiler.The cylinder was also changed to a new duel coil indirect, also the circulating pump for the solid fuel.When the stove is lit at first, there is no circulation in the coil to the cylinder,the pipe stat has to be turned down to 40 degrees to bring in the pump to prevent the water boiling in the stove.The system is making a lot of noise before the pump cuts in,there is a "pressure release" valve on the flow pipe to the coil that i have operated several times and this lets out steam and water.I feel that the stove has not been properly plumbed,and am having trouble getting "plumber"to correct this.I think that there should be a circuit for the water to flow to heat the cold water in the cylinder before the pump supplies heat to the rads?.The cylinder replaced an old one that was not insulated,it is positioned higher than the stove.
Can someone please put up a diagram of how these two systems should be linked up.
thanks in advance
Can someone please put up a diagram of how these two systems should be linked up.
thanks in advance