Just the One
Registered User
- Messages
- 168
I had the immersion turned on the other day and it was not heating very well so I decided to lift the cap and increase the temperature. I noticed that it was a bit wet under the cap where all the wiring is.
I killed power and dried everywhere. Turned up temperature to about 55 degrees. Everything worked fine - water heated. I checked again 2 hrs later when I was turning it off and the roof of the immersion cap was a little wet on the inside. It was similar to condenstation.
Has anyonw any advice where this is coming from????
I killed power and dried everywhere. Turned up temperature to about 55 degrees. Everything worked fine - water heated. I checked again 2 hrs later when I was turning it off and the roof of the immersion cap was a little wet on the inside. It was similar to condenstation.
Has anyonw any advice where this is coming from????