themunsterone
Registered User
- Messages
- 16
Hi all,
I recently purchased an A2 new build and like many that are done in developments around the country, they have hole in the wall vents with crap plastic covers that allow the wind the fly in.
I knew this was the case before purchase but in line with building regulations, the builder was doing nothing wrong. At least it was vented, be it a cheap job. I knew it would be something I would have to get sorted myself.
Anyway, I am not in a position to put in a load of ducting for a mechanical system but I want to at least get rid of the draughts and regulate the flow of air.
I have 4 inch/100mm holes in 400mm thick walls to work with but I am finding it hard to source what I need for that sizing.
Any recommendations on how to go about upgrading what I have?
I recently purchased an A2 new build and like many that are done in developments around the country, they have hole in the wall vents with crap plastic covers that allow the wind the fly in.
I knew this was the case before purchase but in line with building regulations, the builder was doing nothing wrong. At least it was vented, be it a cheap job. I knew it would be something I would have to get sorted myself.
Anyway, I am not in a position to put in a load of ducting for a mechanical system but I want to at least get rid of the draughts and regulate the flow of air.
I have 4 inch/100mm holes in 400mm thick walls to work with but I am finding it hard to source what I need for that sizing.
Any recommendations on how to go about upgrading what I have?