I'm new to actual 'hands on' plumbing and I've recently installed a new
1.4 bar shower pump. all seems fine but I'm pulling my hair out
trying
to stop some weeping where the male threaded part of the fitting meets
the female part of the shut-off valve as shown in the below link.
I firstly tried without any material to seal the joint using only elbow grease
which weeped, then I tried PTFE tape with no luck... it still weeped, I now
have the joints wrapped in Hemp & some copper joint cement, I'm going to
let water into the system this evening to check for weeping, if this weeps
what next???? I saw some white cement in B&Q, this maybe?
[broken link removed]