Hi all,
as the thread title suggests I have a problem with my immersion switch. The on / off switch is suddenly not working. By not working, I mean that it can't be put into the on position - it will only go about half way before meeting some resistance and reverting to the 'off' position. The Bath / Sink part of the switch is working as per usual.
There was an interruption of the water supply to the house for the guts of a day and I'm wondering if this would have caused the problem ? Is it possible that the immersion switch can't be switched on if the cylinder is virtually empty ?? If so, is it just a case of waiting for tanks & cylinders to refill ?
The house is relatively new and the immersion is only used moderately, probably only every 2nd day for about 20 mins a go, so I don't think it's an excessive use problem... as always any advice given will be greatly appreciated
as the thread title suggests I have a problem with my immersion switch. The on / off switch is suddenly not working. By not working, I mean that it can't be put into the on position - it will only go about half way before meeting some resistance and reverting to the 'off' position. The Bath / Sink part of the switch is working as per usual.
There was an interruption of the water supply to the house for the guts of a day and I'm wondering if this would have caused the problem ? Is it possible that the immersion switch can't be switched on if the cylinder is virtually empty ?? If so, is it just a case of waiting for tanks & cylinders to refill ?
The house is relatively new and the immersion is only used moderately, probably only every 2nd day for about 20 mins a go, so I don't think it's an excessive use problem... as always any advice given will be greatly appreciated