This sounds ridiculous to me.Hi to ye all,can you advice.i am just after finding out from my new tenants that there is no immersion heater installed in the hot water tank.The switch with the red light is there alright and working.Im in a state of shock,i thought that an immersion was a standard fitting in all new houses,not so according to the builders foreman
This sounds ridiculous to me.
I second that, It's a cop out. You should have a tapping on the top or side of cylinder that is blanked. If its a standard cylinder with tapping at top, these cost about €35 and should cost no more than €130 to fit including part, labour and vat.
However I would insist that builder/plumber fit one at no extra cost on the grounds it should be included in price of house.
By the way chippy, price depends on location. However one poster here reported on paying around €300 for the job which is far too expensive. A competent plumber should be on site for no more than an hour. My advice is to shop around. Good luck
Once again thankyou DavyJones,price might not be to bad here in limerick please god. Regards Chippy
Me too, but it's true. My brother's tank is missing the immersion too.This sounds ridiculous to me.
Once again thankyou DavyJones,price might not be to bad here in limerick please god. Regards Chippy
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?