I'm making a swing joint to attach to a bed so i can store it upright and lower it when needed.
Here is a diagram of one piece.
[broken link removed]
A: Is a piece of metal that the load of the bed will be bearing down on from directions 2 + 3 when the bed is lying flat.
B: Is a piece of metal that is screwed rigid to the wall.
C: Is a Bolt joining both bits of metal.
A and B have a nylon washer between them and are tightened with a Nyloc nut.
Piece A will be loose enough to swing in direction 1 This will give the bed the ability to pivot.
There is one of these joint each side at the head of the bed.
My questions.
I'm trying to work out if the joint will be strong enough to hold the bed.
It's light weight pine but I'm not sure how much load will be generated when it swings.
I'm not looking for may maths, just opinions on how thick I should make A+B
and How thick a bolt should C be.
Thanks
Here is a diagram of one piece.
[broken link removed]
A: Is a piece of metal that the load of the bed will be bearing down on from directions 2 + 3 when the bed is lying flat.
B: Is a piece of metal that is screwed rigid to the wall.
C: Is a Bolt joining both bits of metal.
A and B have a nylon washer between them and are tightened with a Nyloc nut.
Piece A will be loose enough to swing in direction 1 This will give the bed the ability to pivot.
There is one of these joint each side at the head of the bed.
My questions.
I'm trying to work out if the joint will be strong enough to hold the bed.
It's light weight pine but I'm not sure how much load will be generated when it swings.
I'm not looking for may maths, just opinions on how thick I should make A+B
and How thick a bolt should C be.
Thanks