readysteadygo
Registered User
- Messages
- 39
Hello there,
I'm looking for an engineers installation manual for an Aritech CS450.
I've replaced the digi dialler (last dialler just stopped functioning) but there is still a problem dialling out.
Checked the phone line voltage - its ok, checked the CS450 outputs - there sending the correct signal (i.e. voltage ok and digi set to expect active high).
LED on digi dialler is working ok but the panel displays 'dialler busy' or 'no dial tone'.
Tried adjusting all inputs and outputs without joy, FTC voltage is normal.
The manual would be great as I'm working from memory.
I installed the wiring and panel, etc about six years ago. I've installed / programmed a few panels for friends since then but this is the first dialler I seen act up.
Anyone got an idea?
Thanks.
I'm looking for an engineers installation manual for an Aritech CS450.
I've replaced the digi dialler (last dialler just stopped functioning) but there is still a problem dialling out.
Checked the phone line voltage - its ok, checked the CS450 outputs - there sending the correct signal (i.e. voltage ok and digi set to expect active high).
LED on digi dialler is working ok but the panel displays 'dialler busy' or 'no dial tone'.
Tried adjusting all inputs and outputs without joy, FTC voltage is normal.
The manual would be great as I'm working from memory.
I installed the wiring and panel, etc about six years ago. I've installed / programmed a few panels for friends since then but this is the first dialler I seen act up.
Anyone got an idea?
Thanks.