Hi,
Would like to remove section of our concrete driveway. The driveway has no fancy finish, just floated off but with that extra smooth 4" border that you see on regular pavements.
The cut would be approx 17 ft long and I'm assuming concrete depth is 6 inches.
My main objective is to get a nice smooth/clean edge, ideally with that extra smooth 4" border. I understand that it will never be like original edge as created when it was poured/floated but I was looking for advice on how best to get close to original finish.
Would a consaw be the best option for this? Is it easy to achieve an accurate line?
Or should I look at using a floor saw or a concrete chainsaw?
Will water-fed help with smooth cut or is it just for dust control?
Any ideas on recreating the pavement border?
Thanks,
cybermate